![]() ![]() So we opted to use an Argon M.2 case which has a built in USB 3 to SATA board. After discussing the issue with YouTuber leepspvideo, it turned out that our USB 3 caddy was to blame. The images were successfully written to the drive, and they did indeed boot, but they failed at the device discovery portion of the setup. Keyboard, mouse, HDMI and power for your Raspberry PiĬonfiguring Raspberry Pi to boot off of SSDįor our install we chose to use an SSD via a USB3 caddy with USB boot enabled on the Pi.Bluetooth dongle (if you want Bluetooth).Windows 10 PC (if you are following the longer method).A micro SD card with the latest Raspberry Pi OS.Best for performance or 16GB or larger microSD card, (see best microSD cards for Raspberry Pi) An 32GB or larger SSD via a USB 3 caddy.Plug in the controller and restart the Pi with the controller connected.What you will need to install Windows 11 on a Raspberry Pi 4 When all else fails, there's nothing more reliable than a good old fashioned reboot (just like Grandma used to call for help with). Other devices work when using the same USB port If the connected controller isn't working, verify the controller meets the following criteria: However, it wouldn't be a troubleshooting section without failure. ![]() Setting up a controller should be nothing more than plug-and-play. Adjust the network configuration prior to launching Steam Link. Internet connection settings can be set within Raspberry Pi OS. Be sure your Raspberry Pi is connected to your network and able to reach external domains. It’s hard to connect without a network! A LAN connection alone may not be enough to run Steam Link. Ensure your Pi has a network connection and no prompts are open on the PC instance of Steam. The Pi is not connected to the network, the PC isn’t running steam, or the PC is waiting for you to enter the device authorization code. When the Raspberry Pi is failing to connect to your computer, it’s usually due to one of three things. Here are some of the most common issues you’ll run into while setting up this project and how to fix them. As I always say, it’s not a Raspberry Pi project without a few hiccups. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |